When you’re looking at a chain drive system that’s skipping or binding up, chances are it’s time to check those idler sprockets. This 15-tooth idler for 50 chain keeps everything running smooth and properly tensioned. Whether it’s on a conveyor, elevator, or drive system, a worn idler sprocket can throw off your whole operation.
What You’re Getting
- Precise 15-tooth design that maintains proper chain spacing and smooth operation
- 1/2 inch bore that fits standard shafts without any modifications needed
- Built to handle the constant rotation and tension that idler sprockets face
- Clean, machined finish that reduces wear on your 50 chain
Built for Real Farm Work
This sprocket fits 50 chain systems found throughout agricultural equipment, from grain handling systems to conveyor drives. You’ll find 50 chain on everything from older combine grain elevators to feed mill equipment and material handling systems around the farm.
Made to Last
Idler sprockets take a beating since they’re constantly under tension, so this one’s machined to tight tolerances and built to handle the load. The smooth bore finish makes installation easier and helps prevent shaft wear over time.
Good to Know
Make sure your shaft diameter matches the 1/2 inch bore before ordering. When replacing an idler, it’s a good time to check your chain for wear and proper tension. A little grease on the bore during installation makes the job easier and helps prevent corrosion down the road.
