When your battery isn’t charging or your lights are getting dim, it’s often that little generator belt that’s the culprit. This 28-inch generator belt is what keeps the juice flowing on older International Harvester tractors. When it starts slipping or breaks, you’ll know it fast—no lights, no charging, and a tractor that won’t start the next morning.
What You’re Getting
- Raw edge construction that grips pulleys tight and resists slippage
- 28-inch length with half-inch width for proper fit on generator systems
- Built to handle the constant load changes from generator operation
- Direct replacement for International Harvester generator applications
Built for Real Farm Work
This belt is designed for International Harvester tractors equipped with 6-volt generator systems. These older machines were built tough and simple, and this belt maintains that no-nonsense approach. The generator has to work hard when you’re running lights, ignition, and other electrical components while keeping the battery topped off.
Made to Last
The raw edge design gives this belt better grip than smooth-sided belts, which is important when the generator is under load. Farm work means starting and stopping, varying loads, and temperature changes that can challenge electrical systems. This belt is built to handle those conditions season after season.
Good to Know
Before installing, check your generator pulley and crankshaft pulley for wear or damage. A quick tip: if the old belt was squealing, don’t over-tighten the new one—proper tension should allow about half an inch of deflection when pressed firmly between pulleys. Clean any oil or grease off the pulleys before installation for best grip.
