When your spring tooth cultivator points start wearing down, you’ll notice your field work isn’t as effective as it used to be. Dull or worn points just push through the soil instead of cutting and breaking it up properly, leaving you with poor seedbed prep and uneven cultivation. This replacement point gets your cultivator back to doing what it does best—breaking up compacted soil and preparing a clean, level seedbed.
What You’re Getting
- Sturdy 5/16-inch thick steel construction that holds its edge longer than thinner points
- 2-inch width provides good soil penetration without creating excessive drag
- 11-inch length gives you plenty of working surface before needing replacement
- Two slotted bolt holes with 7/16-inch bolts and flexible 1 to 2-inch spacing to fit various shank configurations
- Direct replacement design that bolts right onto your existing spring tooth shanks
Built for Real Farm Work
This point is designed for spring tooth field cultivators used in secondary tillage operations. Whether you’re working corn stubble, preparing soybean ground, or doing spring field prep, this point handles the job. The spring tooth action lets it flex over rocks and obstacles while maintaining consistent soil penetration across varying field conditions.
Made to Last
The 5/16-inch thickness gives this point the durability to handle rocky ground and abrasive soils without bending or breaking. It’s built to SMA’s quality standards, which means you’re getting a part that’ll hold up to the demands of real farm work season after season.
Installation Notes
The slotted holes make this point easy to position and adjust on your shanks. The 1 to 2-inch bolt spacing accommodates most common shank designs. A quick tip—check all your points at the same time and replace any that are worn more than halfway back from the tip for the best field performance.
